ScreenBeam 1100 can be configured by using the ScreenBeam CMS software or accessing the ScreenBeam’s Local Management Interface (LMI).
Using ScreenBeam CMS Software
ScreenBeam Central Management System (CMS) is a highly recommended complimentary tool for multi-unit deployment, configuration and administration.
- To obtain CMS software and the CMS User Guide, go to https://support.screenbeam.com/cms
- Refer to the CMS User Guide for setup instructions.
Using Local Management on ScreenBeam
The Local Management Interface can configure and update a single ScreenBeam. There are three methods to access the LMI:
Method 1: ScreenBeam Local Access Point
- Connect the client device’s WiFi to the wireless network (AP SSID) as shown on the TV display.
- Enter the password for the wireless network. “screenbeam” is the default password.
- The Ready to Connect screen on the display will show the assigned IP address of the ScreenBeam.
- Enter this address into the web browser of a PC or Apple device.
- If the receiver is not connected to an existing wireless network or LAN, its IP address is 192.168.26.1.
- If the receiver is connected a network, the IP address can be identified on the Ready to Connect screen.
- The browser may give an error stating “The connection or site is not secure or private.” Manually accept the connection as follows:
- For Chrome browser: click Advanced, then click Proceed.
- For Edge/IE browser: click Details, then Go on to the webpage (not recommended).
- For Firefox browser: click Advanced, then click Add Exception, then click Confirm Security Exception.
- When the ScreenBeam management page appears, enter the Username Administrator and Password Actiontec (both case-sensitive).
Method 2: Network Connection via DHCP
- Using a shielded RJ-45-terminated Cat5e or better Ethernet cable, connect the ScreenBeam Ethernet port to a DHCP-enabled network.
- The Ready to Connect screen on the display will show the assigned IP address of the ScreenBeam. Enter this address into the web browser of a PC or Apple device on the same network as the ScreenBeam.
- Follow the directions from Method 1 from Step 5 on.
Method 3: Wireless P2P Direct Connection
- Using a Windows 10/8.1 device, connect the device to the ScreenBeam per Section B above.
- Once connected, use a web browser and enter https://192.168.16.1 to access the LMI.
- Follow the directions from Method 1 from Step 5 on.
Comments
0 comments
Please sign in to leave a comment.